Taunusstein - Germany

+49-6128-9165-0

HydroScreen Fine Bar Screen Model FSRF

Flyer HydroScreen Typ FSRF Technische Unterlagen HydroScreen Typ FSRF Video HydroScreen

The challenge

Even when CSO’s and SSO’s are equipped with scum boards, considerable quantities of floatables and suspended solids still reach the waters. Sanitary articles, toilette paper and synthetics are left caught in the river bank after heavy rain. The waters are biologically and hydraulically “stressed”.

The way

All polluted discharges into receiving waters have to be treaded. Floatables and suspended solids can be screened out. This should be done continuously and carefully to prevent the screenings from breaking up and slipping through the screen mashes.

The solution

The Steinhardt® HydroScreen Fine Bar Screen Model FSRF is a very flat screen. It is installed horizontally at overflows in combined and separate sewer systems. The direction of flow is from bottom to top. All fine bar screens Model FSRF are made of stainless steel and are normally hydraulically driven. Explosion protection is not necessary. The control cabinet can be in any chosen position above ground.

The HydroScreen Fine Bar Screen Model FSRF is modular in design and can be installed through small openings (also Ø 600) and mounted in the structure. The module is about 65 cm long; the smallest unit starts at 1.30 m with integrated hydraulic drive. Waterwheel drive unit on demand. To prevent screenings being carried over the whole length of the screen, each module has rest zones. The screenings are released there by gravity, sink to the floor and are carried by the sewer flow to the WWTP.

The minimum installed width starts at 40 cm, extendable in 10 cm steps. The screen height including the hydraulic drive is less than 30 cm when assembled. It is installed horizontally and partially lowered before existing overflow crests so that the screen bars are evenly charged.  The normal bar spacing is 4 and 6 mm, which ensures the highest possible degree of cleaning by corresponding flow rate. In order to trap as much dissolved matter as possible, the flow velocity between the screen bars is limited to ≤ 1.4 m/s.

Removal of screenings begins automatically when the HydroScreen Fine Bar Screen Model FSRF is charged. It operates continuously during the discharge and is set to continuous operation.

Range of Application

before combined inflows into receiving waters
before storm water inflows into receiving waters
before soil filter systems
before earth and retention basins
before percolations
before difficult-to-clean basins

Advantages

robust stainless steel construction
modular in construction
retrofit through small apertures possible
high cleaning efficiency
safe transport of screenings
wiper elements on the pollution-protected side
very flat screen
velocity between screen bars limited to  ≤ 1.4 m/s
head loss approx. ≤10 cm
effective performance approx. 500 l x s-1 x m-2
bio oil
screenings release zone every 65 cm
no re-adjustment
hydraulic drive
optional waterwheel drive